T7004-MB-V1.0 Dump file Download [100% Tested]

Overview of T7004-MB-V1.0 main board

TV7004 MB V1.0 is a main board chassis used primarily in 4-channel China XVR and DVR security camera recording systems. It operates on an ARM-based system-on-chip (Soc). Features a 16MB SPI Flash memory chip (commonly labeled as W25Q128). This chip contains the embedded Linux kernel and the DVR software application layer.

AHDN-10810404 is a identifier for TV7004 MB V1.0 main board. AHDN-10810404 is the software while the TV7004 MB V1.0 is the hardware main board in which this software is installed.

• TV7004 MB V1.0 main board controls ports (BNC, HDMI, SATA), capacitors, chips, and power delivery.
• AHDN-10810404 is the software that controls user interface, camera compatibility, H.264 compression, and network apps (like XMEye).

It is a budget-friendly security recording hardware, used by many third-party brands that package them into their own plastic or metal chassis.

Common problems fixed by AHDN-10810404 bios file

Flashing the correct BIOS can solve many bios related issues some of them are given below:

• DVR/NVR contain T7004-MB-V1.0 main board doesn't power on properly (no lights, no beeps, nothing happens).
• It fixes T7004-MB-V1.0 main board DVR/NVR system restarts automatically in a loop.
• X No Display / Blank Screen Issues fixed.
• DVR/NVR fan runs at full speed constantly (overheating etc).
• T7004-MB-V1.0 main board DVR/NVR gets stuck in a LOGO (BIOS Recovery Mode).

Bios Flashing Steps:

1. Download the CH341A drivers and open the AsProgrammer software on your computer.
2. Download the required file and extract it using WinRAR or 7Zip (or if you are in andriod phone use ZArchiver).
3. Disconnect the power cable, cameras, and hard drive from the DVR board so it is completely turned off.
4. Find the tiny dot on the W25Q128 memory chip (Pin 1) and attach the test clip, making sure the red wire lines up with that dot.
5. Connect the other end of the clip into the programmer, lock it down, and plug the USB into your PC.
6. In the software, click the Read ID button so it detects your chip.
7. Click Read and save the file as a backup just in case.
8. Click Erase to clear the corrupted, broken software out of the chip.
9. Open your new AHDN-10810404 .BIN file and click Write.
10. Unplug the programmer, remove the clip, plug the DVR power adapter back in, and turn it on to see if it boots up normally.

Note:

1. Make sure to verify configuration before flashing.
2. Smart Led Zone Team is not responsible for any type of damage/loss as a result of Uploading/Downloading the firmware.
3. Software/Firmware file 100% tested by Smart Led Zone Team.